Configuring Network Protocols - Monarch 7411 Operating Instructions Manual

C o n f i g u r i n g N e t w o r k P r o t o c o l s
Only configure the settings required for your network/printer. To enable or
disable protocols:
1. From the side menu, click Admin. The Web Admin Configuration screen
appears.
2. Click Protocol Control.
3. Check or uncheck the network and IP protocols to enable or disable the
necessary protocols.
Note: If you disable the TCP/IP protocol, all IP protocols are disabled
automatically.
4. Click Submit.
5. Click the reset link at the bottom of the screen. The Reset Server screen
appears.
Click Submit and wait five seconds for the printer to reset. Even though
6.
you submitted your changes on the previous screen, they do not take
effect until you reset the printer.
You must re-enter your access password to make any further changes to
the printer settings.
Using the Web Interface 4-19