Onkyo TX-NR801/E Service Manual page 9

REMOTE CONTROLLER
SEND/LEARN indicator
Lights red when signals are sent by the remote con-
troller. It also flashes when a button is pressed and
the battery power is lo w.
ON/STANDBY button
ON: Press to turn on the TX-NR801/TX-NR801E.
STANDBY: Press to place the TX-NR801/
TX-NR801E in the standby state.
Be aware that pressing the STANDBY button only
places the TX-NR801/TX-NR801E in standby and
does not turn the power of f completely.
SLEEP button
Press to set the sleep function.
The SLEEP button enables you to set the
TX-NR801/TX-NR801E to turn of f automatically
after a specified time period.
MACRO 1, 2 button
Press to program or execute the macro function.
MODE buttons and indicators
Press to select the component to be operated by the
remote controller. When a MODE button is pressed,
it will light for 8 seconds. The selected MODE but-
ton will also light whenever any other operation but-
ton is pressed.
RETURN button
Press to enter the selected setting and return to the
previous menu.
CH button
Press to select a preset channel for the tuner.
CH SEL button
Press to select a speaker channel when adjusting the
speak er level.
AUDIO SEL button
Press to select the audio input signal.
LEVEL / buttons
Press to adjust the volume of the speaker selected
using the CH SEL button.
Operation buttons
Press to operate other devices connected to the
TX-NR801/TX-NR801E.
INPUT SELECTOR buttons
Press to select an input source.
Same as the input selector buttons on the front panel
of the TX-NR801/TX-NR801E. The input source
for each button is given here. DVD:DVD, CD:CD,
V1:VIDEO1, V2:VIDEO2, V3:VIDEO3,
V4:VIDEO4, V5:VIDEO5, T AP:TAPE, TUN:FM/
AM, PH:PHONO.
Listening mode buttons
Press to select a listening mode.
Re-EQ button
Depending on the listening mode, you can turn the
Re-EQ function on or of f.
DISPLAY button
For changing the front display
DIMMER button
Adjusts the display brightness.
There are three settings available: normal, dark, and
very dark.
LIGHT button
Press to turn on and of f the lights in the buttons of
the remote controller .
SETUP button
Press to display the Setup Menu on the TV screen
and in the display. Press again to exit the menu.
/ / / , ENTER button
When in the Setup Menu, press the upper and lower
arrow buttons to select an item, press the right and
left arrow buttons to select parameter values or
modes, and press the ENTER button to advance to
the next item.
VOL button
Press to adjust the volume.
TEST button
This button is used to set the speaker output levels.
Use this button in conjunction with the LEVEL
and CH SEL buttons to calibrate the speak er lev-
els without entering the Setup Menu.
MUTING button
Press to activate the mute function.
ZONE 2 button
Press to perform operations in the remote zone.
9
TX-NR801/E
.