Rear Panel View - Onkyo TX-NR801/E Service Manual

REAR PANEL VIEW

DIGITAL PRE OUT
IN
R L
COAX FRONT
1
SUB CENTER
2
SURR
3
SURR
R L
BACK/
OPT
ZONE 2
1
FRONT
MULTI CH
2
INPUT
R L
SUB CENTER
3
SURR
DIGITAL
OUT
R L
OPT
1
SURR
BACK
2
GND
DIGITAL IN/OUT
These jacks are for connecting components with
digital input and output capabilities.
PRE OUT
To use the TX-NR801/TX-NR801E as a preampli-
fier, connect a power amplifier to this jack.
ANTENNA
These jacks are for connecting the FM indoor
antenna and the AM loop antenna that are supplied
with the TX-NR801/TX-NR801E.
ZONE 2 VIDEO OUT
This jack is for connecting the component that will
be used in the remote zone (Zone 2).
MONITOR OUT VIDEO/S VIDEO
These jacks are for connecting to the video input
jacks on tele vision monitors or projectors.
COMPONENT VIDEO OUTPUT
These jacks are for connecting to the component
video input jacks on television monitors or projectors.
ETHERNET (Net-Tune)
This connector is for connecting to an Ethernet network.
SPEAKERS
These terminals are for connecting the speak ers.
AC OUTLETS
This AC outlet is provided to plug in the po wer cord
from another component. The shape and number of
the AC outlet depend on the shipping destination.
COMPONENT
VIDEO S VIDEO
AUDIO
ANTENNA
VIDEO
OUTPUT
MONITOR
OUT
Y
AM
OUT ZONE 2 P B
R L
IN DVD
P R
INPUT 1
FM
OUT Y
75
VIDEO 1
IN P
B
AUDIO
R L
PHONO OUT P
R
IN
VIDEO 2
INPUT 2
CD IN Y
IN
OUT
VIDEO 3 P
IN B
TAPE
IN VIDEO 4 P
R
IN
R L R L
AUDIO AUDIO VIDEO S VIDEO
FRONT SPEAKERS SURR SPEAKERS
R L R L
ETHERNET
( Net-Tune )
CENTER
SPEAKER
CAUTION:
R L
SPEAKER
IMPEDANCE
4 OHMS MIN. OR
I R
6 OHMS MIN.
/SPEAKER
IN MODEL NO.
SEE INSTRUCTION
MANUAL FOR REMOTE
CONTROL
CORRECT SETTINGS.
OUT
MULTI CH INPUT
This connector is for connecting components with a
multichannel output.
PHONO/CD/TAPE AUDIO IN/OUT
These connectors are for connecting to the audio
input and output jacks on audio components.
DVD/VIDEO1-4 IN/OUT
These connectors are for connecting to the video
input and output jacks on video components.
COMPONENT VIDEO INPUT1/2
These connectors are for connecting to the compo-
nent video outputs of video components that have
them.
IR IN/OUT
These connectors are for connecting the remote sen-
sor of a multi-room kit (sold separately).
This jack is for connecting other Onkyo compo-
nents equipped with the same
audio connection cables must also be connected.
V O LTAGE SELECTOR (World wide models
only)
This is only av ailable on the worldwide model.
Before connecting the po wer cord to the wall outlet,
be sure to set this to the correct po wer supply volt-
age for your region.
7
TX-NR801/E
AC OUTLETS
AC 120 V 60 Hz
SWITCHED
TOTAL 120W 1A MAX.
SURR
BACK/
ZONE 2
SPEAKERS
VOLTAGE
SELECTOR
120V
AV RECEIVER
TX-NR 801
220-230V
terminal. The