Klark Teknik HELIX SYSTEM DN9344 Operator's Manual page 31

abc
l
Touchstrip operation with Parametric equalisation
On the Parametric EQ page, the touchstrip can be used to select the currently-active section of
EQ. This is achieved by pressing either the upper or lower part of the strip below the centre
frequency of the chosen section. The centre frequency will highlight to indicate the selection.
Once selected, the frequency of the EQ section can be "dragged" up and down the display by
pressing the strip and sliding the point of contact to left and right. There is no difference
between the upper and lower strips when in Parametric mode.
23