Klark Teknik HELIX SYSTEM DN9344 Operator's Manual page 29

abc
l
Touchstrip operation with Graphic equalisation
On the Graphic EQ page, the touchstrip can be used as an alternative to the encoder knobs for
selecting and operating the faders on the display. Touch either the upper or lower part of the
touchstrip below the fader that you want to select. The fader will highlight to indicate the
selection. Tapping repeatedly at the same position will result in the fader moving up (upper
strip) or down (lower strip) in 0.5dB increments. Pressing the strip continuously in the same
place will result in the fader ramping up or down over its full range. As an aid to resetting faders
to exactly 0dB, this ramping motion will stop as the fader passes over the 0dB position. Release
the strip and then press again to continue moving past this point.
Grouping
Simultaneous touch in both parts of the strip
Groups of faders can be created and moved together. This is achieved by pressing below one
fader on the upper strip, and below a different fader on the lower strip. A group will be created
including all faders between those two that have been selected. This can now be moved up and
down using the encoder knob or by using the touchstrip in the area below the group. Pressing
the touchstrip outside the range of the group or moving the "frequency" encoder knob will
disband the group.
21