Quick Reference - Klark Teknik HELIX SYSTEM DN9344 Operator's Manual

Quick reference:

Power ON indication.
The left, centre and right encoder knobs -
used for controlling values and selecting
options.
Alphanumeric display - this shows parameter
values for the current function being
controlled by the encoder knobs.
Soft keys for selecting options and secondary
functions.
This area of the main graphic display labels
the soft key functions. Typically these
include "select" to choose a particular filter,
and "menu" to step round a circular choice of
options for that type of EQ. On the home
page these buttons access the gain, delay,
naming functions.
Main graphic display - this shows the
frequency response of the selected type of
EQ, or the overall response on the home page.
EQ active lights - these show if a particular
type of EQ is currently affecting the overall
frequency response.
Access keys to control each type of
equalisation - press HOME(SETUP) key to
return to the home page.
If you have received the unit in an unknown
state, and wish to clear it down to ensure
that no EQ is active, please refer to the
information on page 29.
DN9340
Power switch.
Output metering incorporating multi-point
clip indication.
T-DEQ
Input metering incorporating multi-point clip
indication.
HOME(SETUP) key. Press once to return to
the home page. Once on the home page, press
and hold for one second to access the Setup
menu. Step through the Setup menu (and exit
after the last item) by repeatedly pressing this
key.
STORE and RECALL keys. Used to store
complete unit settings to one of the 64
memory locations and then to recall them.
PC port connector. Use with the supplied
cable to install software updates or to control
the unit from an external computer.
Two part touchstrip. Press either part briefly
to select a particular filter or fader.
Graphic EQ mode, press and hold to increase
the level (upper strip) or reduce it (lower
strip).
Channel select key. Press to select either
channel A or B for control. If the unit is linked
for stereo operation then both indicators will
be lit.
Bypass key - on the home page this bypasses
the complete unit for the selected channel
(both channels if linked). When a particular
EQ type is selected (by the keys above the
bypass switch), the bypass operates on that
type of EQ only.
5
abc
l
dynamic EQ metering.
In