Rear Panel Connections - Boss RC-300 Owner's Manual

Panel Descriptions

Rear Panel Connections

Adjusting the input level
Adjust each [INPUT LEVEL] knob so that the PEAK indicator lights
only occasionally, when the level of the input is at its highest.
INPUT MIC jack
Connect your microphone here.
[PHANTOM]
switch setting
If you're using
a condenser
microphone, choose
the "ON" setting. If
you're using a dynamic
microphone, choose
the "OFF" setting.
* Ordinarily, this is set
to "OFF."
Security slot
( )
http://www.
MAIN OUTPUT jacks
kensington.com/
Connect these jacks to your amp or monitor
speakers.
If your system is monaural, use only the OUTPUT
L jack. Sound that was input in stereo will also be
output monaurally.
SUB OUTPUT jacks
Connect these jacks to your mixer or other equip-
ment. The sound of a specific track, the audio
input, or sound from a computer connected via
USB can be output from the SUB OUTPUT jacks
independently of the MAIN OUTPUT jacks (p. 33).
6
INPUT AUX jack
INPUT INST jacks
Use a stereo mini-plug cable to
Connect your guitar, bass,
connect your audio player here.
or effects unit to these
jacks.
Use the INPUT L jack
and INPUT R jack when
connecting a stereo-
output effects unit. Use
only the INPUT L jack if
you're using a monaural
source.
DC IN jack
Connect the included AC
adaptor here.
* Use only the included
PHONES jack
Connect
a set of
headphones
(sold
separately)
here.
[POWER] switch
This turns the power on/off (p. 7).
CTL 1, 2/EXP 2 jack
CTL 3, 4/EXP 3 jack
You can connect EXP pedals
(EV-5, etc. ; sold separately) or
foot switches (FS-5U, FS-6; sold
separately) here, and use them
to control a variety of parameters
(p. 24).
AC adaptor. Using any
other adaptor may
cause overheating and
malfunction.
To prevent the
inadvertent
disruption of
power to your
unit (should the
plug be pulled out
accidentally), and
to avoid applying
undue stress to
the DC IN jack,
anchor the power
cord using the
cord hook, as
shown in the
illustration.
MIDI
connectors
For connecting
USB connector
MIDI d evice ( p. 3 8).
You can also
You can use a
connect an
commercially available
additional
USB cable to connect
RC-300 unit for
the RC-300 to your
synchronized
computer, and use the
playback.
computer to read/write
RC-300 tracks (WAV files).
You can play sounds
from your computer through the RC-300 via USB
audio (p. 36).
About USB cap
If you want to connect a USB cable, detach the
USB cap that covers the USB connector. Leave the
USB cap in place when you're not using the USB
connector.