Furuno GP-1670 Operator's Manual page 16

1. OPERATIONAL OVERVIEW
Control
TM
RotoKey
POINTS/GO
TO key
EVENT/MOB
key
ENT key
ESC/MENU
key
HOME/CTRL
key
CursorPad
SD card slot: Card drive for SD card (chart card and memory card).
Mini USB connector: Connects to a PC. (Mouse or USB flash memory cannot be con-
nected.)
RESET button: Resets the program. Should the screen freeze press this button to re-
start.
SD cards
The SD cards store ship's tracks, routes, points, settings, etc. The unit
accepts SD and SDHC (Secure Digital High Capacity) type cards and
the maximum capacity is 32 GB.
To set a card in the slot, insert the card label side up. If the card does not go in easily,
do not use force. Push the card until the card is in position.
To remove a card, Select [Eject SD card] from the RotoKey menu.
Remove the card (with your fingers) after the message "You can eject SD card safely."
appears.
Care and handling of SD cards
• Handle the cards carefully; rough handling can damage the card and destroy its con-
tents.
• Make sure the cover is closed at all times. Insert the card fully or remove the card;
the cover cannot be closed if the card is inserted partially.
• Remove a card with only your fingers. Do not use metal instruments (like tweezers)
to remove the card.
• Do not remove a card during the reading of the card or writing to the card, to prevent
damage to the card and loss of the data stored on the card.
• If water is at the bottom of the cover, DO NOT open the cover. Remove the water
with a dry cloth completely and then open the cover.
1-2
Short-push: Display the base RotoKey
mode.
Long-push: Display the full RotoKey
mode.
Short press: Put a point at cursor position.
Long press: Set cursor position as destination.
Short press: Put a point at current position.
Long press: Put an MOB (ManOverBoard) mark at current position.
Confirm current operation.
Short press: Escape from current operation.
Long press: Open the menu.
Short press: Display the home page, where you select a display.
Long press: Switch the active display in combination modes.
Moves the cursor and scrolls the screen, in the direction of the arrow
pressed.
Description
TM
soft controls for the current
TM
soft controls for the current