B Uz Z Er - Miele G 1 series Operating Instructions Manual

A d d itio nal fu nc tio ns
B u z z er
A n audible tone sounds at the end of
the programme or if there is a fault.
Y ou will hear the buz z er at the end of a
programme in bursts of five with a short
pause in between. The buz z er will
continue to sound for up to an hour if
y ou do not switch the dishwasher off.
In the event of a fault, the buz z er will
sound continuously for up to two
minutes if y ou do not switch the
dishwasher off or correct the fault.
The buz z er is activated as standard at
the factory .
Y ou can deactivate the buz z er at the
end of a programme if y ou wish. The
buz z er will still sound if there is a fault,
even if it has been deactivated.
^ O pen the door.
^ S witch the dishwasher off with the O ff
button V.
^ P ress the programme selector button
in, and w h ilst h o ld ing it in switch
the dishwasher on using the O n
button U .
K eep the programme selector button
pressed in until the lower right hand
programme indicator comes on.
If this does not happen, start the
procedure from the beginning again.
42
^ P ress the Turbo/Tab button four
times.
The Tab indicator light will flash briefly
four times at intervals.
The message flashing in the Time left
display shows whether the buz z er at
the end of the programme is activated
or deactivated.
– "p 1": The buz z er is activated.
– "p 0": The buz z er is deactivated.
^ To change the setting, press the
programme selector button.
The setting is now stored in memory .
^ S witch the dishwasher off with the O ff
button V.