Insufficient Salt Indication - Miele G 1 series Operating Instructions Manual

^ R emove the lower basket and
unscrew the salt reservoir cap.
W ater or saline solution will run out
of the reservoir when the cap is
removed. It should therefore only be
removed in order to refill the salt
reservoir.
^ F ill the reservoir with approx . 2 litres
of water (first use only ).
^ P lace the funnel provided over the
salt reservoir and carefully fill with
salt until the reservoir is full. The salt
reservoir holds approx . 2 kg of salt.
^ C lean any ex cess salt from around
the reservoir opening and then screw
the cap on again fir m ly .
^ R un the Q uick wash programme im-
mediately (without any crockery in
the dishwasher, and without selecting
the "Turbo" ex tra option) to remove
any traces of salt from the cabinet.
B efo r e u sing fo r th e fir st tim e
Insu ffic ient salt ind ic atio n
^ F ill the salt reservoir with dishwasher
salt when the salt indicator light
comes on. (If it comes on during a
programme, wait until the end of the
programme).
A fter the reservoir has been filled, the
water softener is automatically
reactivated the nex t time the
dishwasher is run. The salt indicator
light may still be illuminated during this
process. It will go out once the salt
concentration has reached the correct
level.
The salt indicator is deactivated when
the dishwasher has been programmed
to a water hardness level below
0.7 mmol/l (4 ° d).
,
R un the Q uick wash programme
immediately (without any crockery in
the dishwasher, and without
selecting the "Turbo" ex tra option) to
remove any traces of salt from the
cabinet.
19