Sony DVP-S300 Training Manual page 56

Third Generation DVD
The third generation DVD players consist of models DVP-S330, DVP-
S530, DVP-S550 and DVP-C650d.
Symptom 4: Unit goes back to standby mode during
playback or after being left ON in the stop mode.
Pressing the MB board makes the unit remain on
longer.
Cause: Broken solder connection at a major IC stops the communica-
tions chain and the unit goes into protection by powering OFF (standby).
Repair Procedure
1. Remove the capacitors around IC401 for clearance and resolder all
the pins. If you created solder bridges, you have not applied liquid
flux (Kester flux pen) at the foot of the IC legs or you touched the legs
close to the IC body with the iron. Remove the bridges with thin brad
solder wick. Inspect each pin carefully, then remount the electrolytic
capacitors.
Heat only the
feet and lands
2. While you have the MB board out, resolder the pins on IC206; and
3. Resolder the pins on IC202.
IC Body
Do NOT apply
heat here
53