Sony DVP-S300 Training Manual page 102

Please confirm whether your unit applies to any item below: 1 - 2 when, replacing IC802. Then, if it's so,
solder CAPACITOR ,
0.1 uF on Motor- if necessary secure with some double sided tape.
1. Please confirm the name and part number of TK board, which is installed in each model. (Except DVP-
F11. For F11, refer to NOTE #2.) If it has the target digit (last 2 digits) of part number below, connect
the capacitor 0.1 uF ,between CN004 Pin 13 and Pin 14 on TK board. (Refer to the figure on the page 3
/4.)
NAME
TK-51 BOARD
TK-53 BOARD
PART NUMBER
1-164-159-51
LAST 2 DIGITS OF PART #
-11 / -12
-11
PART NAME
CERAMIC CAPACITOR 0.1UF
MODEL NAME
DVP-CX850D/S330
DVP-S530D/S550D
DVP-C650D