Kenmore 970R4241 Series Use & Care Manual page 28

Care & Cleaning
Part
Interior & •
Door Liners
•
Door Gaskets •
Drawers & •
Bins
Glass Shelves •
•
•
Toe Grille •
•
•
Exterior &
•
Handles
•
Exterior &
•
Handles
•
(Stainless
Steel Models
Only)
Replacing •
Light Bulbs
•
•
•
•
•
Care & Cleaning Tips
What To Use
Soap and water
Baking soda and
water
Soap and water
Soap and water
Soap and water
Glass cleaner
Mild liquid sprays
Soap and water
Mild liquid sprays
Vacuum attachment
Soap and water
Non Abrasive Glass
Cleaner
Soap and water
Stainless Steel
Cleaners
Unplug refrigerator
Wear gloves
Remove light cover
Replace old bulb
Replace light cover
Plug in the
refrigerator
Tips and Precautions
Use two tablespoons of baking soda in
one quart of warm water. Be sure to
wring excess water out of sponge or
cloth before cleaning around controls,
light bulb or any electrical part.
Wipe gaskets with a clean soft cloth.
Use a soft cloth to clean drawer runners
and tracks.
Allow glass to warm to room temperature
before immersing in warm water.
Vacuum dust from front of toe grille.
Remove toe grille (see Installation
Instructions). Vacuum backside, wipe with
sudsy cloth or sponge. Rinse and dry.
Do not use commercial household
cleaners containing ammonia, bleach or
alcohol to clean handles. Use a soft cloth
to clean smooth handles. DO NOT use a
dry cloth to clean smooth doors.
Never use CHLORIDE or cleaners with
bleach to clean stainless steel.
Clean stainless steel front and handles with
non-abrasive soapy water and a dishcloth.
Rinse with clean water and a soft cloth. Use
a non-abrasive stainless steel cleaner. These
cleaners can be purchased at most home
improvement or major department stores.
Always follow manufacturer's instructions.
Do not use household cleaners containing
ammonia or bleach.
NOTE: Always clean, wipe and dry with
the grain to prevent scratching. Wash the
rest of the cabinet with warm water and
mild liquid detergent. Rinse well, and wipe
dry with a clean soft cloth.
CAUTION: Wear gloves when replacing
light bulbs to avoid getting cut.
Use same wattage when replacing bulb
28