Admin > Firmware Upgrade; Admin > Reboot; Admin > Factory Default - Linksys SLM248G4S (G5) User Manual

Chapter 
Admin > Firmware Upgrade
Admin > Firmware Upgrade
The Firmware Upgrade screen allows you to download
firmware upgrade files from a TFTP server, or from your
computer via the HTTP interface.
Va TFTP Select this to download from or upload to a
TFTP server. When you select this option, the following
fields are displayed.
UPGRADE
Select this option to upgrade the switch
•
from a file located on a TFTP server.
Fle Type Select the type of file to download,
•
either Software Image or Boot Code.
TFTP Server
Enter the TFTP Server IP Address that
•
contains the source file to upgrade from.
Fle Name Enter the name of the upgrade file on
•
the TFTP Server.
BACKUP
To back up the firmware to a TFTP server,
•
enter the TFTP server address.
TFTP Server
Enter the TFTP Server IP Address to
•
which the firmware file will be saved.
Fle Name Displays the name of the firmware file.
•
This field cannot be edited.
Va HTTP
Select this to download an upgrade file using
the HTTP interface. When you select this option, the
following field is displayed:
Source Fle Enter the name and path of the file or
•
click Browse to locate the upgrade file.
Click Save Settngs to begin the download or upload.
24/48-Port 10/100 + 4-Port Ggabt Reslent Clusterng Smart Swtch wth 2 Combo SFPs
Configuration Using the Web-based Utility
Admin > Reboot
The Reboot screen is used to reset one Switch or the entire
stack. From the drop-down menu, select the unit number
or Stack, then click Reboot, then click OK to confirm. The
configuration settings are automatically saved before the
system reboots.
Admin > Reboot
Admin > Factory Default
The Factory Default screen allows network managers to
reset the Switch to the factory defaults shipped with the
switch. This results in erasing the configuration file.
NOTE:
Restoring factory defaults erases all
current configuration settings. You can save a
copy of your configuration settings beforehand
using the Admin > Save Configuration screen.
Admin > Factory Default
4