Multicast > Bridge Multicast; Multicast > Bridge Multicast Forward All - Linksys SLM248G4S (G5) User Manual

Chapter 
Auto Learn
Select this option to enable Auto Learn on the
device. If Auto Learn is enabled, the device automatically
learns where other Multicast groups are located. The
default is enabled (option is selected).
Host Tmeout
Indicates the amount of time host waits to
receive a message before timing out. The default time is
20 seconds.
MRouter Tmeout Indicates the amount of the time the
Multicast router waits to receive a message before it times
out. The default value is 00 seconds.
Leave Tmeout Indicates the amount of time the host
waits, after requesting to leave the IGMP group and not
receiving a Join message from another station, before
timing out. If a Leave Timeout occurs, the switch notifies
the Multicast device to stop sending traffic The Leave
Timeout value is either user-defined, or an immediate
leave value. The default timeout is 10 seconds.
Click Update to update the screen with your changes.
Click Save Settngs to save the changes, or Cancel
Changes to cancel the changes.
Multicast > Bridge Multicast
The Bridge Multicast screen displays the ports and LAGs
attached to the Multicast service group in the Ports and
LAGs tables. The Port and LAG tables also reflect the
manner in which the port or LAGs joined the Multicast
group.
Multicast > Bridge Multicast
Ports can be added either to existing groups or to new
Multicast service groups. The Bridge Multicast screen
permits new Multicast service groups to be created. The
Bridge Multicast screen also assigns ports to a specific
Multicast service address group.
24/48-Port 10/100 + 4-Port Ggabt Reslent Clusterng Smart Swtch wth 2 Combo SFPs
Configuration Using the Web-based Utility
The Bridge Multicast screen contains the following fields:
VLAN ID Identifies a VLAN to be configured to a Multicast
service.
Brdge Multcast Address
MAC address/IP address.
Brdge IP Multcast Displays the port that can be added
to a Multicast service.
Interface, Ggabt, LAG
that can be added to a Multicast service. The configuration
options are as follows:
Statc Indicates the port is user-defined.
•
Dynamc Indicates
•
dynamically.
Forbdden
Forbidden ports are not included the
•
Multicast group, even if IGMP snooping designated
the port to join a Multicast group.
None The port is not configured for Multicast service.
•
Click Add to Lst to add the configured static multicast
address to the table at the bottom of the screen.
Click Show All to display all multicast addresses on all
VLANs in the table at the bottom of the screen.
Click Save Settngs to save the changes, or Cancel
Changes to cancel the changes.
Multicast > Bridge Multicast Forward All
The Bridge Multicast Forward All screen contains fields for
attaching ports or LAGs to a device that is attached to a
neighboring Multicast router or switch.
Multicast > Bridge Multicast Forward All
Once IGMP Snooping is enabled, Multicast packets are
forwarded to the appropriate port or VLAN.
Identifies the Multicast group
Lists switch interfaces and LAGs
the port is configured