TRENDnet TEW-817DTR User Manual page 19

TRENDnet User's Guide
Note: It is recommended that a wireless key (passphrase or password) is created
before connecting clients using the PBC method. By default your router is
preconfigured with a wireless encryption key. If no wireless key is defined when
connecting via PBC, the router will automatically create an encryption key that is 64
characters long. This 64 character key will then have to be used if one has to
connect computers to the router using the traditional connection method.
To add a wireless device to your network, simply push the WPS button on the wireless
device you are connecting (consult client device User's Guide for length of time), then
push and hold the WPS button located on your router for 3 seconds and release it. The
WPS LED will blink to indicate WPS has been activated on your router. (See
Hardware Features" on page 4)
For connecting additional WPS supported devices, repeat this process for each
additional device.
PBC (Software/Virtual Push Button)
Advanced > Wireless (2.4GHz or 5GHz) > WPS
In addition to the hardware push button located physically on your router, the router
management page also has push button which is a software or virtual push button you
can click to activate WPS on your router.
1. Log into the management page (see
2. Click on Advanced, then click on Wireless (2.4GHz or 5GHz), and click on WPS.
3. To add a wireless device to your network, next to Virtual Push Button, click the Start
Push Button button in the router management page. Then push the WPS button on the
wireless device (consult wireless device's User's Guide for length of time) you are
connecting.
4. Wait for your router to finsh the WPS process.
Note: You should a message on your WPS client device indicating WPS was successful.
© Copyright 2015 TRENDnet. All Rights Reserved.
"Access your management page" on page 7).
"Product
PIN (Personal Identification Number)
Advanced > Wireless (2.4GHz or 5GHz) > WPS
If your wireless device has WPS PIN (typically an 8-digit code printed on the wireless
device product label or located in the wireless device wireless software utility), you can
use this method.
1. Log into the management page (see
2. Click on Wireless, and click on Wi-Fi Protected Setup.
3. To add a wireless device to your network, next to Client, enter the 8-digit numeric PIN
number of the wireless client device and click Start PIN. Note: You may need to initiate
the WPS PIN on your wireless device first when using this method. Refer to your wireless
device documentation for details on the operation of WPS.
4. Wait for your router to finsh the WPS process.
Note: You should a message on your WPS client device indicating WPS was successful.
TEW-817DTR
"Access your management page" on page 7).
18