Correct Usage - Toshiba RAV-SM562MUT-E Owner's Manual

CORRECT USAGE

When you use the air conditioner for the first time or when you change the SET DATA value, follow the proce-
dure below. From the next time, the operation displayed on the remote controller will start by pushing the
ON / OFF
button only.
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute,
*
but it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with
switch and the leak breaker.
4
1
ON / OFF
Push button.
The operation lamp goes on, and the operation starts.
2
Select an operation mode with the
MODE
"MODE " button.
One push of the button, and the display
changes in the order shown on the right.
• In HEAT mode, if the room temperature reaches to the set temperature, the outdoor unit stops and
the air flow becomes LOW and the air volume decreases.
3
Select air volume with "
One push of the button, and the display
changes in the order shown on the right.
• When air volume is "AUTO
• In DRY mode, "AUTO
• In heating operation, if the room temperature is not heated sufficiently with VOLUME "LOW
tion, select "MED.
4
Determine the set up temperature by pushing the "TEMP.
Stop
ON / OFF
Push button.
The operation lamp goes off, and the operation stops.
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET CL
FAN
" button.
", air volume differs according to the room temperature.
" is displayed and the air volume is LOW.
" or "HIGH " operation.
ON / OFF
button without turning off the main power
ON / OFF
FAN MODE
SWING/FIX VENT
UNIT
AUTO HEAT
AUTO
" or "TEMP.
6
1
3
2
DRY COOL FAN
HIGH MED. LOW
" opera-
" button.