Connecting Wires To Terminals - Kenwood KVT-7012BT Instruction Manual

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connection

Connecting wires to terminals

Connect the antenna cord
to the antenna terminal.
USB terminal (0.8 m):
Pages 58 – 59
Pages 58 – 59
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Antenna control wire)
Blue with white stripe (Power control wire)
Brown (Mute control wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
Purple with white stripe
(Reverse sensor wire)
10 A fuse
Connect SiriusXM Connect Vehicle Tuner
(commercially available). See page 59.
*
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type antenna. (Max. 300 mA, 12 V)
When using the optional power amplifier, connect to its power control terminal.
Not used.
To use the steering wheel remote control feature, an exclusive remote adapter
(not supplied) matching your car is required.
To car light control switch
(ACC)
(BATT)
(GND)
Connect to the vehicle's reverse lamp harness when
using the optional rear view camera.
Light green (Parking
sensor wire) 3
* If no connections are made, do not let the cable come out
from the tab.
To car chassis
Connect to the vehicle's parking
brake detection switch harness.
• For best safety, be sure to
connect the parking sensor.
Ignition key switch
Fuse box
Battery
ENGLISH 57