Attaching The Work Bowl Cover; Installing The Adjustable Slicing Disc - KitchenAid KFP1330 Instructions Manual

aSSEMblINg ThE FOOd PROCESSOR
attaching the wor_k bowl cover_
NOTE: Be sure to install the desired accessory before attaching the work bowl cover.
Place the work bowl cover on the work
1
bowl with the feed tube just to the left
of the work bowl handle. Grasp the feed
tube and turn the cover to the right until
it locks into place.
NOTE: Your Food Processor will not
operate unless the work bowl and work
bowl cover are properly locked on the
base, and the large pusher is inserted to
the maximum fill line on the feed tube
(approximately halfway down).

Installing the adjustable slicing disc

IMPORTaNT: The adjustable slicing disc can only be installed in one direction.
With the work bowl installed, place the
1
drive adapter on the power shaft of the
base.
10
Fit the food pusher into the 3-in-1
2
feed tube. See "Using the 3-in-1 Feed
Tube" for details on working with
different sized foods.
Holding the adjustable slicing disc by
2
the 2 finger grips, align the pins on the
adjustable slicing disc adapter with the
L-slots on the disc. Slide the disc down
onto the adapter and turn to engage
the pins in the L-slot.