Chapter 3 — Configuration
NOTE: Your DVR should be completely installed before proceeding. Refer to Chapter 2 — Installation.
Front Panel Controls
HDD LED
NOTE: The infrared sensor on the DVR is just to the top of the Power LED. Make certain that nothing blocks
the sensor, or the remote control will not function properly.
When you use wireless communication devices (such as Wi-Fi or Bluetooth) near the DVR, the remote
control might not function properly.
You can also use a USB mouse to navigate through the screens and menus much like you would on a
computer.
HDD LED
The HDD LED flickers when the DVR is recording or searching video on the hard disk drive.
Power LED
The power LED is lit when the unit is On.
Alarm LED
The Alarm LED is lit when alarm output or internal buzzer is activated.
USB Port
Connect the supplied USB mouse to one of the ports. The USB mouse will be used to access many of the DVR's
functions. A USB flash drive can be connected for backup or system upgrades.
Figure 3: DVR front panel.
Power LED
Alarm LED
Digital Video Recorder
USB Port
7