Select Blower Option And Install Ductwork - Broan Elite RM60000 SERIES Installation Instructions Manual

1. SELECT BLOWER OPTION AND INSTALL DUCTWORK

Either an interior or exterior blower or in-line blower may be used with this hood. The Broan Elite RM60000 Series must be
installed with blower models RM325H, RM326H, HLB3, HLB6, HLB9, HLB11, 331H, 332H, 335 or 336 only.
Other blowers cannot be substituted. (Blowers sold separately).
NOTE: In addition to the blower models listed above, this hood is also compatible with older internal versions 325H
and 326H. However, discard the installation instructions included with those blowers and contact our technical
support to obtain replacement instruction.
Plan where and how the ductwork will be installed.
If installing in-line blower, refer to instructions packed with in-line blower and follow steps 1 up to 6, 9, 10, 11,
13 and up of this manual.
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. Use 2" duct tape to
seal duct joints.
ROOF CAP
DECORATIVE
12"
FLUE
(305 mm)
or SOFFIT
HOOD
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE
HH0024A
MODEL RM325H SINGLE BLOWER
TYPICAL DUCTWORK
EXTERIOR BLOWER
DECORATIVE
FLUE 12"
or SOFFIT
(305 mm)
HOOD
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE
HH0026A
MODEL 331H, 332H, 335 OR 336
EXTERIOR BLOWER TYPICAL DUCTWORK
7" (178 mm)
ROUND DUCT
WALL CAP
7" (178 mm)
ROUND
ELBOW
10" (254 mm)
ROUND DUCT
10" (254 mm)
ROUND ELBOW
EXTERIOR
BLOWER
332KR
ROUGH-IN KIT
(see page 5)
- 6 -
ROOF CAP
12"
DECORATIVE
FLUE
(305 mm)
or SOFFIT
HOOD
24" TO 30" (609 to 762 mm)
ABOVE COOKING SURFACE
HH0025A
MODEL RM326H DUAL BLOWER
TYPICAL DUCTWORK
10" round duct
In-line blower
Hood
24" to 30"
(609 to 762 mm)
above cooking
surface
HH0066A
MODEL HLB3, HLB6, HLB9 OR HLB11
IN-LINE BLOWER TYPICAL DUCTWORK
10" (254 mm)
ROUND DUCT
WALL CAP
4-1/2" x 18-1/2"
to 10"
(114 x 470 to
254 mm) ROUND
TRANSITION
(see page 4)
Roof cap
Wall
cap