8
Automatic Convenience Options
The PowerCode
enhance security and comfort. Some of these features are
programmable at the time of installation. Please see your installer for
further details.
Illuminated Entry
When the alarm system is disarmed, the vehicle courtesy lights will turn
on for 1 minute, or until the vehicle is started or the system is re-armed.
Illuminated Exit
When removing the key from the ignition, the vehicle courtesy lights
will turn on for 1 minute, or until the PowerCode
Automatic Arming
The Power Code
removed from the ignition. This feature can be temporarily disabled by
placing the system into Valet mode.
Ignition Lock
If all doors are closed and the vehicle is started with the key, the doors
will automatically lock.
Ignition Unlock
When removing the key from the ignition, the doors will automatically unlock.
When Your Security System is Triggered
The PowerCode PC 7600
occurs while the system is armed:
• Any protected entrance is opened
• The vehicle ignition is turned on
• The vehicle is jolted hard enough to signal the impact detector
Once the alarm is triggered, the siren (or horn) sounds and the
vehicle parking lights flash for 30 seconds. The system will then re-
arm, awaiting the next intrusion attempt. To stop the siren while
keeping the alarm armed and doors locked, press the ARM button
while the system is triggered.
The Status Indicator is a high-intensity red light mounted in a visible
location on the vehicle dashboard. This red light gives a visual
indication of the alarm system's state of operation. Note the chart
below:
If the Status Indicator is...
Flashibg Green
Flashing Slowly
Flashing Very Quickly
Flashing Intermittently
(2 flashes, off, 2 flashes)
On (not flashing)
TM
performs a variety of automatic functions to
TM
will arm automatically 1 minute after the key is
TM
will trigger if one of the following events
TM
....then the Security System
is disarmed
is armed
was triggered in your absence
(see Attempted Intrusion ID - page 4)
is in Valet mode ( LED is Green)
is in Pre-arm mode
is armed.
Need help?
Do you have a question about the PC 7600 and is the answer not in the manual?
Questions and answers