Begin The Rf Manager Setup Wizard - HP MSM415 Hardware Installation

„ Network Detector/Sensor/ND Combo Mode: For this mode, use the command set
vlan config. This command configures the IP addresses on the ND.

Begin the RF Manager Setup Wizard

1. Log in to the HP ProCurve RF Manager Console using the default username: admin and
password: admin. The Welcome to HP ProCurve RF Manager System Setup Wizard screen
appears as shown in the following figure.
This wizard takes you through the steps to help you initialize HP ProCurve RF Manager. Click
Next on each screen to proceed to the next step. To go back to a previous step, click
Previous. To exit the setup wizard at any point, click Exit. You can take a tour of this wizard
later through the Console from Administration > Global Tab > System Settings >
Wizards and configure the appropriate settings. Click Start.
Getting Started
Begin the RF Manager Setup Wizard
2-11