Getting Started
Quick Setup
Quick Setup
1. Power up the RF Manager by connecting it to a power source.
2. Connect Port 1 of the RF Manager to the Network using a network interface cable.
Warning
The default IP address of the RF Manager Controller is 192.168.1.246. Ensure that no other
device on your network uses the same IP address as the controller. Connect port 1 on the
controller to the desired subnet using the network interface cable provided. Do not connect
the High Availability (HA) Interface port to the subnet.
3. Access the HP ProCurve RF Manager Server.
a.
b. Change your computer IP address to 192.168.1.XXX. For example, 192.168.1.244.
c.
d. Login using the Username: config and Password: config.
4. Complete the Server Initialization and Setup Wizard. Follow the steps in the Server
Initialization and Setup Wizard to configure the HP ProCurve RF Manager Server.
2-2
Connect your computer to the same subnet where the Server is connected.
Access the HP ProCurve RF Manager Server using SSH as shown in the figure below.