Page of 6
   
MSM415 RF Security Sensor
Quick Start Guide
Abstract
The MSM415 RF Security Sensor is a single- 1 1n radio
security sensor that continuously scans the 2.4 and 5 GHz
bands to detect and counter-attack security threats for
802.1 1a/b/g/n wireless devices and APs. This document
describes how to install and initially configure the MSM415,
hereafter referred to as the sensor. The latest documentation
is available at www.hp.com/support/manuals.
© Copyright 2015 Hewlett-Packard Development Company, L.P.
HP Part Number: 5998-7420
Published: February 2015
Edition: 1
*5998-7420*
Hardware
2. Lock tab
3. Cable channel
4. Ethernet port (Port 1)
5. Console port
6. Mounting bracket tab slots
MSM415, mounting bracket, two mounting screws
with wall anchors, and documentation.
Page 1

Advertising

   Also See for HP MSM415

   Related Manuals for HP MSM415

   Summary of Contents for HP MSM415

  • Page 1: Package Contents

    Quick Start Guide Hardware Abstract The MSM415 RF Security Sensor is a single- 1 1n radio security sensor that continuously scans the 2.4 and 5 GHz bands to detect and counter-attack security threats for 802.1 1a/b/g/n wireless devices and APs. This document describes how to install and initially configure the MSM415, hereafter referred to as the sensor.

  • Page 2: Reset Button, Status Leds

    — The sensor is experiencing a slowly software error. The following table indicates various MSM415 Sensor states using the LEDs on the sensor device. Because The sensor is not powered on or it is in the process of starting up.

  • Page 3

    Ethernet cables. Cables with the bracket. large boots may not insert into the RJ-45 connectors properly. HP recommends that you do not use such Mounting on a wall-mounted electrical box cables. Disconnect power and take any other needed Plenum installation: The MSM415 and appropriate security precautions.

  • Page 4: Specifications

    Observe the status LEDs on the sensor. If all LEDs glow green, the sensor is operational and connected to the server. Log on to the HP RF Manager server through SSH. Run the get sensor list command. You will see a list of all sensors that are recognized by the server.

  • Page 5

    35 50, +7 (727) 355 35 51 Manufacturing Date – The manufacturing date is included in the product serial number, CCYMPPPZZZ (HP serial number format for this product). The Related information manufacturing date is indicated by YM in the serial...

  • Page 6

    Documentation feedback Send any errors, suggestions, or comments to Documentation Feedback (docsfeedback@hp.com). Page 6...

Comments to this Manuals

Symbols: 0
Latest comments: