Table of Contents
Advertisement
Environmental
Temperature:
Relative humidity:
(non-condensing)
Maximum altitude:
Acoustic
Noise Emission LwA=52 dB at virtual work space according to DIN 45635 T.19.
Connectors
The 10/100/1000 Mbps RJ-45 twisted-pair ports are compatible with the following standards:
■
IEEE 802.3ab 1000Base-T
■
IEEE 802.3u 100Base-TX
IEEE 802.3 10Base-T
■
Safety
Complies with:
EN60950-1 / IEC 60950-1
■
■
CSA 22.2 No. 60950-1
■
UL 60950-1
Installing the RF Manager
Powering Up and Shutting Down
Caution
The RF Manager is powered on when it is connected to a power source.
To shut down RF Manager, always use either the keypad and LCD display, located on the
front of the RF Manager, or the Command Line Interface (CLI). This is particularly important
during initial bootup. Do not shut down RF Manager by disconnecting its power.
See Shutting Down, in the Additional Configuration chapter of the HP ProCurve RF Manager
and Sensors Management and Configuration Guide.
Installation Precautions
Take these precautions when installing the RF Manager.
Warnings
■
The rack or cabinet should be adequately secured to prevent it from becoming unstable and/or
falling over.
Units installed in a rack or cabinet should be mounted as low as possible, with the heaviest
devices at the bottom and progressively lighter devices installed above.
■
For safe operation, only install the RF Manager horizontally, with the bottom side down.
Operating
5°C to 40°C (41°F to 104°F)
15% to 80% at 40°C (104°F)
2 km (6,500 ft)
Non-Operating
-40°C to 65°C (-40°F to 149°F)
20% to 90% at 65°C (149°F)
4.6 km (15,000 ft)
Hardware Installation
Installing the RF Manager
1-5
Advertisement
Table of Contents
