Axis Q1635 User Manual page 15

AXIS Q1635 Fixed Network Camera
Access the Product
Note
These controls are available if digital PTZ is enabled in the selected view area or if a PTZ driver has been uploaded. For more
information on view areas, see View Area on page 27. For more information on how to upload a driver, see Install PTZ Driver
on page 36. To switch between the two options see PTZ Mode on page 12.
Click the Emulate joystick mode button and click in the image to move the camera view in the direction of the
mouse pointer.
Click the Center mode button and click in the image to center the camera view on that position.
The center mode button could also be used to zoom in on a specific area. Click in the image and drag to draw a
rectangle surrounding the area to be magnified. To zoom out, rotate the mouse wheel.
Focus bar – Click on a position on the focus bar to set the focus position. This will disable the product's autofocus. To re-enable, use
the PTZ control panel which is opened by clicking the Ctrl panel button (see above). If autofocus is enabled, Auto is visible next to
the Focus bar. For more information about the autofocus function, see Image Settings on page 27.
Iris bar – Click on a position to set a manual exposure level to make the image brighter or darker. This will disable auto iris (automatic
exposure) and set fixed levels on iris, gain and shutter speed. To re-enable auto iris, use the PTZ control panel which is opened by
clicking the Ctrl panel button (see above). If auto iris is enabled, Auto is visible next to the Iris bar bar.
Important
In an environment with varying light conditions it is recommended to use the Brightness bar instead of the Iris bar to adjust
image brightness since changing the brightness level will not disable auto iris (automatic exposure).
The PTZ controls can be disabled under PTZ > Advanced > Controls, see Controls on page 35.
Click the Ctrl panel button to open the PTZ control panel which provides additional PTZ controls.
User-defined buttons can also appear in the Control panel. See Controls on page 35.
To view a specific view area or preset position, select it from the Source list.
15