Sport Pro Handheld Device Components; Replacing The Handheld Device Battery - Garmin Sport PRO Owner's Manual

Sport PRO Handheld Device
Components
Security screws
Back plate
Battery
Battery connector
Front plate
Gasket
Replacing the Handheld Device
Battery
Before you can replace the battery, you
must remove all dirt, water, and debris
from the device. You also need the
12
security screwdriver included in the battery
replacement kit.
1
Remove the security screws from the
back of the device.
2
Lift up the back plate.
3
Grip the battery connector wires close
to the connector, and pull the
connector perpendicular to the circuit
board to disconnect the battery
connector from the device.
4
Remove the old battery from the back
plate, noting the orientation of the
battery.
The battery fits tightly. It may be
necessary to pry the battery out of the
back plate using a non-sharp, non-
metal object.
5
Install the new battery into the back
plate with the label side up, using the
same orientation as the old battery.
6
With the new battery, connect the
battery connector to the device.
When properly installed, the connector
plug snaps into the port.
7
Verify the gasket is not damaged and
is completely seated in the groove on
the front half of the device.
Device Information