Table of Contents
Advertisement
Operating temperature range
Charging temperature range
Storage temperature range (up
to 1 mo.)
Storage temperature range (up
to 3 mo.)
Storage temperature range (up
to 1 yr.)
Water rating
*The device withstands incidental exposure to water of up to 1 m
for up to 30 min. For more information, go to
/waterrating.
Checking the Battery Charge Level of the
Dog Collar Device
Turn on the dog collar device.
The status LED flashes every few seconds while the device is
on. The color of the status LED indicates the battery charge
level.
Green
The battery has a good charge.
Yellow
The battery has less than a 50% charge.
Red
The battery should be charged soon.
Flashing Red The battery should be charged immediately. Training
features are disabled.
Delta XC Battery Replacement Instructions
This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use a sharp object to remove batteries.
Contact your local waste disposal department to properly
recycle the batteries.
Delta XC Handheld Device Components
Security screws
Back plate
Battery
Battery connector
Gasket
Replacing the Delta XC Handheld Device Battery
Before you replace the battery, you must remove all dirt, water,
and debris from the device. You also need the security
screwdriver included with the new battery.
You can purchase a replacement battery at
http://buy.garmin.com. You should use only an official Garmin
replacement part.
6
From -20° to 50°C (from -4° to 122°F)
From 0° to 40°C (from 32° to 104°F)
From -20° to 60°C (from -4° to 140°F)
From -20° to 45°C (from -4° to 113°F)
From -20° to 30°C (from -4° to 86°F)
IEC 60529 IPX7*
www.garmin.com
WARNING
CAUTION
1
Remove the six security screws from the back of the device.
2
Lift up the back plate.
3
Grip the battery connector wires close to the connector, and
pull the connector parallel to the circuit board to disconnect
the battery connector from the device.
4
Remove the old battery from the back plate, noting the
orientation of the battery.
The battery fits tightly. It may be necessary to pry the battery
out of the back plate using a non-sharp, non-metal object.
5
Install the new battery into the back plate with the label side
up, using the same orientation as the old battery.
6
With the new battery, connect the battery connector to the
device.
When properly installed, the connector plug snaps into the
port.
7
Verify the gasket is not damaged and is completely seated in
the groove.
8
Hold the back plate and the device firmly together, and
replace all six security screws without tightening.
9
Verify the back plate and the device are aligned with no gaps.
10
Tighten the screws evenly.
Delta XC Dog Collar Device Components
Battery assembly
Gasket
Battery connector
Device
Security screws
Replacing the Delta XC Dog Collar Device Battery
Assembly
Before you replace the battery, you must remove all dirt, water,
and debris from the device. You also need the security
screwdriver included with the new battery.
You can purchase a replacement battery assembly at
http://buy.garmin.com. You should use only a certified Garmin
replacement part. The battery assembly includes a pre-
assembled back plate with a gasket, battery, and battery
connector.
1
Remove the four security screws from the corners of the
device.
2
Lift up the battery assembly.
3
Grip the battery connector wires close to the connector, and
pull the connector outward from the circuit board to
disconnect the battery connector from the device.
4
With the new battery assembly, connect the battery
connector to the device.
When properly installed, the connector plug snaps into the
port and the top face of the connector plug is flush with the
edges of the port.
5
Verify the gasket is not damaged and is completely seated in
®
the groove.
Device Information
Hide quick links:
Advertisement
Table of Contents
