Sanyo PLC-XP30 User Manual page 35

Optical Adjustment
Fig. 1c
[R-FOCUS ADJUSTMENT]
1. Input Green grid signal..
2. Press the ZOOM (
size) and press the FOCUS (FAR) or (NEAR) button
to make a picture in sharp focus.
3. Input Red grid signal.
4. Loosen the 4 screws "B" with the 2.0mm hex driver,
see Fig.1b.
5. Insert the slot type screwdriver in the slots
and (Fig.1b) and gently turn the screwdriver until
the each corner of screen is in sharp focus. The rela-
tion of adjustment points and screen corners are indi-
cated with , , and
6. Tighten the 4 screws "B" and securely attache the
Red panel unit.
Blue
LCD
Panel
3
) button, (to increase image
,
shown in Fig.1b and Fig.2.
Red
LCD
Panel
Fig. 1b
4
[B-FOCUS ADJUSTMENT]
1. Input Green grid signal..
2. Press the ZOOM (
size) and press the FOCUS (FAR) or (NEAR) button
to make a picture in sharp focus.
3. Input Blue grid signal.
4. Loosen the 4 screws "C" with the 2.0mm hex driver,
see Fig.1c.
, 5. Insert the slot type screwdriver in the slots
and (Fig.1c) and gently turn the screwdriver until
the each corner of screen is in sharp focus. The rela-
tion of adjustment points and screen corners are indi-
cated with ,
6. Tighten the 4 screws "C" and securely attache the
Blue panel unit.
-35-
The numbers indicate the focus
effective part when moving the
numbered adjusting slots on
Fig.1.
) button, (to increase image
, and shown in Fig.1c and Fig.2.
, ,