Installing Batteries - Nonin Onyx II 9560 Instructions For Use Manual

Symbol
IP32
pin
BDA
Ver
NOTE: Where applicable, an additional label bearing your country radio communications license information will
appear on the side of your device. This is not a serial number or device identifier.

Installing Batteries

Two 1.5 volt AAA-size batteries power the Model 9560 for approximately 600 spot checks. Nonin recommends using
alkaline batteries (included with each new Model 9560). When batteries are low, the numeric displays flash once per
second. Remove batteries if the device will be stored for more than 30 days. Replace low batteries as soon as
possible, using the instructions below.
NOTE: Rechargeable batteries may be used; however, they require more frequent replacement.
1. Hold the Model 9560 as shown in figure A. To release the device's battery tray, press upward and then pull
outward slightly with the thumb.
2. Remove the old batteries from the battery tray. Dispose of the batteries properly.
3. Insert two new 1.5 volt AAA-size batteries. Follow the polarity markings (+ and -) as illustrated in figure B.
Proper positioning of the batteries is essential for operation.
4. Carefully guide the battery tray back onto the device. Press downward and then push inward slightly to re-
secure the battery tray. Do not force it into place; it fits only when properly positioned.
5. Visually inspect to ensure that the battery cover is properly placed.
6. Insert your finger in the device to verify operation. See the Activating the Onyx II 9560 and Verifying Operation
section for more information.
Remote Alarms; Not for Continuous Monitoring.
Protected against vertically falling water drops when enclosure is tilted up to 15 degrees and
ingress of solid foreign objects greater than or equal to 2.5 mm (0.1 in.) in diameter per
IEC 60529.
R
®
Bluetooth
Indoor use (France only)
Continua Certified™ signifies that this product has been tested and proven to be interoperable
with other products that carry the "Continua Certified" symbol.
RoHS Compliant (China)
Personal Identification Number
Bluetooth Device Address
Version
A
Definition of Symbol
B
C
3