Water Valves - Bosch SHE4AM12U Repair Instructions

5.4.2 To remove door latch
Tools needed: T20 Torx & #2 Phillips screwdrivers and pliers or
wrench.
1. Remove toe kick – section 5.1.4.1
2. Disconnect & pull out dishwasher – section 5.1.4.2.
3. Remove frame stiffener by removing (4) T-20 Torx four
screws (below left).
4. Remove door latch by removing (1) T-20 screw and
rotating the latch up away from the tank tabs (below center
and right).
5.5

Water valves

Access the water valve from the front of
the dishwasher base by removing the toe
kick.
702_58300000130262_ara_en_c
5.5.1 To remove water valve
Tools needed: T20 Torx & #2 Phillips screwdrivers and pliers.
1. Remove outer door – section 5.1.2.1.
2. Remove toe kick – section 5.1.4.1
3. Remove base insulation (on models with insulation).
4. Turn off water and disconnect water line (below left).
5. Turn off electricity and disconnect electric supply by
unplugging power cord or disconnecting wire harness /
loosening strain relief (below center & right).
6. Remove two (2) T-20 Torx screws from water valve (below
left).
7. Disconnect wire harness from water valve (below center).
8. Pull valve out from dishwasher, loosen hose clamp and
disconnect water hose from rear of valve (below right).
Remove any water from sump & base.
Page 29 of 50