Bosch SHE4AM12U Repair Instructions page 25

5.2.2 Fascia panel mounted controls (front button models)
Controls are easily removed from fascia panels by prying plastic
tabs.
Tools needed: T-20 Torx & flat blade screwdrivers.
1. Remove fascia panel – section 5.1.2.2.
remove outer door first.
2. To separate panels from dishwashers with separate short
wire harnesses, disconnect harness connectors from both
ends of fascia panel (see below).
4
1. Connector
3. Control jumper harness
5. Handle tray
702_58300000130262_ara_en_c
If needed,
1
1
2
3
6
5
2. On/off switch harness
4. On/off switch
6. Control
3. Disconnect wire harnesses from control.
4. Remove handle trays (1) before removing controls (2). To
remove handle trays, carefully pry in plastic clips.
1
2
5. Remove controls by carefully prying clips from one side to
the other (below left) and gently lifting controls up as you
pry clips.
6. When reassembling fascia panels to doors, make sure
fascia panel tabs enter outer door slots.
m CAUTION – 80% of all controls returned
for analysis check out OK.
issues are due to loose connections.
Most control
Page 25 of 50