Repair; Access - Bosch SHE4AM12U Repair Instructions

5

REPAIR

5.1

Access

5.1.1 Repair access chart
Use the following chart to determine how to access parts.
serviceable -
no removal
Part serviced
Control / display
Base mounted control
Door latch sensor
Door latch
Dispenser
Water valve
Filters / spray arms / fill tube
Sump access
Hinges
Lower door seal
Fascia panel
On/off switch
Terminal block
Drain pump
Float
Water inlet system
Condensation tube
Heat pump
Aqua sensor
702_58300000130262_ara_en_c
Front Side / front
serviceable - serviceable -
pull out pull out & flip
needed dishwasher dishwasher
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
5.1.2 Front access
Bottom
Many parts such as door latch Hall Effect sensors (1), dispensers
(2), controls (3), and fascia panels (4) are accessed from the
front. Removing the outer door is needed for dispenser and
bottom front access.
5.1.2.1 To remove outer door
Removing the outer door is needed for front access for removing
dispensers and bottom access / flipping dishwashers upside-
down for removing heaters and circulation pumps.
X
dishwashers, the short bottom six (6) screws hold outer doors.
X
Tools needed: T20 Torx screwdriver.
X
1. Remove six (6) short T-20 Torx inner door screws below
X
fascia panel -- three per side (next page, left).
2. Carefully pull bottom of outer door out from dishwasher
until top door tabs clear, then pull door down until it
releases from dishwasher (next page, right). Take care to
not scratch outer door.
1
2
3
4
For most
Page 20 of 50