STARTER MOTOR
4. Reassemble the starter housing and clutch
assembly by assembling the clutch shaft, spring
and starter clutch (Figure 10-24).
Figure 10-24
( 1 )
Figure 10-24
1 – Clutch Shaft
2 – Spring
3 – Starter Clutch
5. Reassemble the clutch shaft and starter clutch
assembly, starter housing, compression spring,
retainer, pinion gear and stop collar
(Figure 10-25).
Figure 10-25
( 1 )
Figure 10-25
1 – Clutch Shaft and Starter Clutch
2 – Starter Housing
3 – Compression Spring
4 – Retainer
5 – Pinion Gear
6 – Stop Collar
10-12
( 3 )
( 2 )
0005411
( 6 )
( 5 )
( 4 )
( 3 )
( 2 )
0005412
© 2007 Yanmar Marine International
6. While pressing down the pinion gear and starter
housing, install the new snap ring using snap
ring pliers. Check that the snap ring is installed
completely in position (Figure 10-26).
Figure 10-26
Figure 10-26
7. Tap in the clutch shaft with a plastic hammer
and install the stop collar onto the snap ring
(Figure 10-27).
Figure 10-27
Figure 10-27
6LPA Service Manual
Starter
0005413
0005415