Starter Disassembly - Yanmar 6LPA-STP2 Service Manual

STARTER MOTOR

Starter Disassembly

1. Remove the terminal nut and disconnect the
lead wire from the magnetic switch terminal
(Figure 10-2).
Figure 10-2
Figure 10-2
2. Remove the screw, washer and lead wire from
terminal 50 (Figure 10-3, (1)).
Figure 10-3
Figure 10-3
3. Remove the 2 through bolts (Figure 10-4, (1))
and spring washers then pull the field coil frame
from the magnetic switch, together with the
armature and remove the felt washer from the
rear bearing.
10-6
Figure 10-4
4. Remove the 3 screws (Figure 10-5, (1)) from
0005566
Figure 10-5
( 1 )
0005390
© 2007 Yanmar Marine International
Figure 10-4
the starter housing and then remove the starter
housing and clutch assembly, return spring,
plate washer, bearing and idler gear from the
magnetic switch assembly (Figure 10-6).
Figure 10-5
6LPA Service Manual
Starter
( 1 )
0005391
(1)
0005392