Headlamp Beam Aiming - BOMBARDIER Alpine 1987 Operator's Manual

Remove capscrew locking chain tenslo-
ner in place. (Tensioner is located at
bottom left of gearbox.)
A017003031
A017003032
6
mm
(114")
max.
free-play
Rotate the tensioner as required to ob-
tain correct chain tension.
Replace capscrew to lock chain tension-
er in place.
Headlamp beam aiming
The angle of the headlamp beam has
been pre-adjusted prior to delivery.
Should you wish re-adjustment, place
the vehicle on a flat surface 7.6 m (25')
from a wall or screen.
With the suspension correctly adjusted,
the rider seated on the vehicle and the
high beam ON check that the center of
high intensity zone of high beam is 50
mm (2") below horizontal line of head-
lamp height.
Headlamp center line\
C:@!
A002004010
Headlamp horizontal
center line
Light beam center
A002004007
7.6 m (25'1
50 mm (2"1
Below headlamp center
Light beam (high beam
project on the wall)
50 mm (2")
To adjust, turn upper or lower adjusting
screws to obtain desired beam position.
Adjusting
A002004008
screw
_________________________ 31