Amplifier Mounting; Mounting Location - Spectron SP-A1500D Owner's Manual

AMPLIFIER MOUNTING

MOUNTING LOCATION

Check the suitability of your preferred amplifier location carefully, before you start
installation attempts. Always try to choose a place where you can be sure nothing
gets damaged behind or below the panel, by drilling the holes for the amplifier mounting
screws. Be aware that after the amp has been mounted, there should be a clearance
of at least 5cm on all sides, for best cooling and to access the side panel for the
adjustments of the electronic crossover.
Attention! For your own safety, disconnect the positive battery termi-
nal (+12V) or remove the main fuse of the 12V power cable, before
you start any wiring work!
Once the location where the amplifier will be mounted is found, use the unit as a
template and mark the mounting holes with pencil or felt-tip marker. Pilot-drill the
these holes, using a 2,5mm or 3mm drill bit on your power drill. Insert the supplied
rubber washers into the mounting holes of the amp. The amplifier must be mounted
totally isolated from the vehicle' s chassis ground, or metal parts. Now bolt the unit in
place with the supplied self tapping screws.
30