Table of Contents
Advertisement
Leveling 30/36" Model
CAUTION
To protect property and refrigerator from damage,
observe the following:
•
Protect vinyl or other fl ooring with cardboard,
rugs, or other protective material.
•
Do not use power tools when performing levelling
procedure.
To enhance the appearance and maintain perfor-
mance, the refrigerator should be level.
Materials Needed
•
1/4" hex head driver.
•
Carpenter's level.
If your refrigerator seems unsteady or
you want the door to close more easily, use
the instructions below.
1. Remove the base grille. Grasp the
grille fi rmly and pull it toward you.
2. Raise or lower the cabinet.
Leveling screw
Using a ¼" hex driver, turn the leveling
screw on each side to raise or lower that side
of the refrigerator.
NOTE: Having someone push against
the top of the refrigerator takes some weight
off the leveling screws. This makes it easier
to turn the screws. It may take several turns
of the leveling screw to adjust the tilt of the
refrigerator.
■ To raise, turn the leveling screw clock-
wise.
■ To lower, turn the leveling screw coun-
terclockwise.
A. Leveling screw
3. Open the door again to make sure that
it closes as easily as you like. If not, tilt the
refrigerator slightly more to the rear by turning
both leveling screws clockwise. It may take
several more turns, and you should turn both
screws the same amount.
4. Replace the base grille.
7
Use & Care Guide
A
Advertisement
Table of Contents
