Table of Contents
Advertisement
Ice
Problem
Refrigerator is leaking water
Ice forms in inlet tube to ice maker.
Water fl ow is slower than normal
Possible Causes
Plastic tubing was used to complete
water connection.
Improper water valve was installed
Water pressure is low.
Freezer temperature is too high
Water pressure is low
Improper water valve was installed.
Copper tubing has kinks
Water fi lter is clogged or needs to be
changed.
36
Use & Care Guide
What To Do
The manufacturer recommends using
¼" o.d. copper tubing for installation.
Plastic is less durable and can cause
leakage. The manufacturer is not
responsible for property damage due
to improper installation or water
connection.
Check water connection procedure
(see page 13). Self-piercing and 3/16"
saddle valves cause low water pres-
sure and may clog line over time. The
manufacturer is not responsible for
property damage due to improper
installation or water connection.
Water pressure must be between 35 to
100 pounds per square inch to function
properly. A minimum pressure of 35
pounds per square inch is recommend-
ed for refrigerators with water fi lters.
Reverse Osmosis water systems cause
low water pressure.
Adjust freezer control (see page 14).
Freezer is recommended to be approxi-
mately 0°F (-18°C).
Water pressure must be between 35 to
100 pounds per square inch to function
properly. A minimum pressure of 35
pounds per square inch is recommend-
ed for refrigerators with water fi lters.
Reverse Osmosis water systems cause
low water pressure.
Check water connection procedure
(see page 13). Self-piercing and 3/16"
saddle valves cause low water pres-
sure and may clog line over time. The
manufacturer is not responsible for
property damage due to improper
installation or water connection.
Turn off water supply and remove
kinks. If kinks cannot be removed,
replace tubing.
Change water fi lter (see page 20).
Advertisement
Table of Contents
