Table of Contents
Advertisement
trigger output socket will likewise be 0V.
CONSTANT.
When the remote power
switch is set in the CONSTANT position,
the power on and off states of the AMC
XA are controlled by the front panel
master power on/off switch.
NOTE: The bi-color power LED above the
front panel power switch, indicates the
power status of the XA. This LED will light
up RED when the XA is in stand-by mode
and GREEN when turned on.
8. IR IN & IR OUT
IR signal from rooms or IR OUT of other
units can be connected to the 3.5mm mini
IR IN jack on the rear panel of XA. So, XA
can be controlled by the IR remote control
in each room through IR sensor. There is
IR OUT as buffered output of IR IN for
controlling units hooking up to XA or
operating as daisy chain for the IR signal
passing through the system.
9. FUSE
There is T2AL 250 fuse put inside the
fuse holder besides AC Inlet. Replace
always with the same type of fuse.
FRONT PANEL.
1.POWER SWITCH AND POWER.
The press button switch marked power
can be used to switched the XA on or off.
When the XA is switched on, the led
above the power switch will light up.
6
Advertisement
Table of Contents
