Sherwood RX-4105 Operating Instructions Manual page 11

Adjusting the tone(bass and treble)
.
8
Enter the tone mode.
¦ U Each time this button is pressed, the corresponding
tone mode is selected and shown for 3 seconds as
follows:
Note:
¦ U When the tone direct function is activated, the tone
mode cannot be entered and "TON DIR" flickers for 3
seconds.
.
9
At the desired tone mode, adjust the tone as
desired.
¦ U If the tone display disappears, start from the step 8
again.
§ š Notes:
¦ U Extreme settings at high volume may damage your
speakers.
¦ U In general, the bass and treble levels are adjusted to 0.
.
10
To listen to a program source without the
tone effect.
¦ U "TON DIR" is displayed , "DIRECT" lights up and the
sound that bypasses the tone circuitry will be heard.
¦ U To cancel the tone direct function, press this button
again to display "TON CTRL", and then "DIRECT"
goes off".
Adjusting the sound volume balance
.
11
Enter the balance mode.
¦ U "BAL" and the balance level is displayed for 3 seconds.
.
12
Adjust the sound volume balance between
the left and right speakers.
¦ U If the balance display disappears, start from the step
11 again.
§ š Note:
¦ U In general, the balance level is set to 0.
11