Console Report Codes - Linear PERS-2400 PERSONAL EMERGENCY REPORTING SYSTEM RA-2400 Programming Manual

Ra-2400 remote access software program for personal emergency reporting system

Hide thumbs Also See for PERS-2400 PERSONAL EMERGENCY REPORTING SYSTEM RA-2400:

Table of Contents

4.9.3

CONSOLE REPORT CODES

PURPOSE:

To view and edit the eight Console report codes. These codes are sent

for Console events such as the Console emergency button, inactivity

alarm, Console low battery and battery restore, no AC and AC restoral.

Activity On & Off reports occur when the Console's activity timer is turned

on or off. The cancel report occurs when the Console's CLEAR button

is pressed during an alarm. The Automatic Test Report occurs every 1,

7, or 30 days if the Automatic Test Report is enabled (see Section 4.8).

No AC and AC restoral reporting is not supported in Versions 1.0 to 1.4.

NOTE: These report codes are sent for both 4 by 2 General and

4 by 2 Point-by-Point Reporting.

USER RESPONSE:

Enter a new two-digit report code for any Console event that needs

to be changed.

NOTE: Entering a "0" for a report code will prevent that event from

reporting.

Table of Contents