Advertisement
18
Flushmount Installation
Re m o v e c a n o p y b o t t o m c o v e r
f r o m c a n o p y b y t w i s t i n g
counterclockwise.
Remove set screws and pins from
yoke as inset shown.
21
L o o s e n t w o p r e a s s e m b l e d
screws across from each other
corresponding to the open slotted
holes on the canopy upper rim and
remove the other two screws from
mounting bracket. Keep screws for
later use.
24
Supply
circuit
Make wiring connections as indicated
above.Connect black and blue wire from
fan to Black or (Hot) wire from house.
Connect White wire from Fan to White
(Neutral) wire from house.
Ground leads from mounting bracket
to Ground lead from house. Refer to
Safety Tips section of manual.
27
Place blade bracket onto blade
by aligning the 3 holes on blade
as shown.
19
Remove every other screw as
circled and save screws for
later use.
Pass leadwires and safety
cable through canopy.
22
H a n g f a n f r o m m o u n t i n g
bracket by the hands free
hook into a closed hole on
the edge of the Canopy.
25
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the wire
connections, the wires should be spread apart
Connect
with the grounded conductor and the equipment-
grounding conductor on one side of the outlet
box and ungrounded conductor on the other side
of the outlet box. The splices after being made
should be turned upward and pushed carefully up
into the outlet box.
28
Install blade bracket with blade by
3 blade screws provided. Tighten
securely. Repeat this process for
remaining blades.
20
Place the canopy over the yoke
screws, aligning the large holes
from the canopy over the screws
on the yoke. Re-install the 3 screws
removed in step 19 to secure the
canopy.
Safety cable installation
Hand free
23
hook
Safety cable
Lag screw
Lag screw
Safety cable
Washer
Lock washer
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod mode the safety cable must be installed
into the house structure beams using the 3" lag
screws,washers, and lock washers. provided. Make
sure that when the safety cable is fully extended the
leadwires are longer than the cable and no stress is
placed on the leadwires.
26
Lift fan to mounting bracket,
aligning the "L" shape holes with
the scresws on the mounting
bracket. Turn the fan clockwise
to lock in position. Re-nstall
the 2 canopy mounting bracket
screws removed in step 21.
29
Check motor for shipping stabilizers
and remove if present. Install the blade
assembly to motor using the screws
pre-installed. Tighten screws securely.
Repeat this process for remaining blade
assemblies.
Shipping
stabilizer
Advertisement
