Monte Carlo Fan Company 5BR52XXD Series Instructions Manual page 5

30
Loosen 3 and remove 1 preassembled
scews from the plate on motor. Save
screw for later use.
33
Attach capacitor and wattage
l i m i t e r o n t o l i g h t p a n b y
preadhered double-sided foam
tap as shown.
36
Attached light fixture on to the light
pan, aligning the keyhole slots with
the preassembled screws on the light
pan. Twist clockwise till lock. Install
the screw removed in step 34. Tighten
all screws securely.
39
Attached bottom cage onto
glass as shown.
31
Place light pan over wires from motor.
Attached light pan on to the plate on
motor, aligning the keyhole slots with
the preassembled screws on the plate.
Twist clockwise till lock. Install the screw
removed in step 30. Tighten all screws
securely.
34
L o o s e n 2 a n d r e m o v e 1
preassembled screw from
the light pan. Save screw for
later use.
37
Install 3 x 40-watt candelabra base
bulbs. Bulbs included.
WARNING: Over lamping the fan
will result in the fan lights shutting
down until the proper wattage of
bulbs are installed.
Reset the lights by turning off,
r e p l a c e b u l b s w i t h t h e c o r r e c t
wattage bulbs, turn the power on.
40
Install the finial removed in step
35 to secure the bottom cage with
glass. Corresponding to step 41
to make sure pull chain align with
knurled grommet on light fixture,
and bottom cage.
32
Hook
Connect plug from fan to plug
from light pan. Make sure the
plugs are hooked together.
35
Remove finial and screw nut from
light fixture.
Connect white wire from light pan
to white wire from light fixture.
Connect blue wire from light pan to
black wire from lighgt fixture.
38
Place glass over the threaded
rod and secure it by the screw
nut removed in step 35. Tigthen
securely.
41
Place pull chains through the
k n u r l e d g r o m m e t o n l i g h t
fixture, and bottom cage as
shown.
This side up