Page 1
This appliance must be installed by an authorised person. • Only use this appliance in a well ventilated area. • Read the instructions before use. FOR USE IN AUSTRALIA THETFORD AUSTRALIA PTY LTD 41 LARA WAY CAMPBELLFIELD VIC TEL: 03 9358 0700 FAX: 03 9357 7060...
Page 5
FIG. 1 CONTROL POSITIONS FULL RATE LOW RATE FIG. 2 APPLIANCE LOCATION...
Page 6
FIG.3 SERIES 162 & 167 WORKTOP CUTOUT FIG.4 SERIES 164 WORKTOP CUTOUT...
Page 7
FIG. 5 SERIES 169 WORKTOP CUTOUT FIG. 6 SERIES 169 WORKTOP CUTOUT (FLUSH MOUNTING)
Page 9
FIG.12 SERIES 162, 164, 167 & 169, TOP MOUNT SEAL & CLAMPING FIG. 13 SERIES 162, 164, 167 & 169, FLUSH MOUNT SEAL & CLAMPING FIG.14 SERIES 910, 920, 921, 922, 930 & 960, HIDDEN SEAL & CLAMPING...
Page 10
FIG.15 SYMBOLS DESCRIPTION Do not remove the pan support and enclose the burner with a wok stand as this will concentrate and deflect heat onto the hotplate Do not place anything, e.g. flame tamer, asbestos mat, between pan and pan support as serious damage to the appliance may result Do not use large pots or heavy weights which can bend the pan support or deflect flame onto the hotplate...
Page 11
INTRODUCTION In your own interest of safety, gas appliances should be installed by competent persons. Failure to install the appliance correctly could invalidate any warranty or liability claims. This appliance shall be installed in accordance with the manufacturer’s installation instructions, local gas fitting regulations, municipal building codes, AG5601 and any other relevant statutory regulations.
OPERATION The burners are controlled individually and each is monitored by a thermocouple probe. In the event the burner flames are accidentally extinguished, turn off the burner control and do not attempt to re-ignite the burner for at least one minute. 1.
INSTALLATION A cut-out should be prepared in the worktop, and the appliance fixed in position – see Figs 3 to 11 for details of worktop cutout for each model A direct distance of 200mm must exist between the edge of the appliance burners and any combustible material, unless protected by a layer of non-combustible material.
Who to Contact For service, please contact your authorised local Service Agent giving full details of the model, serial number and date of purchase. Manufactured by: THETFORD Limited. Unit 19 Oakham Drive, Parkwood Industrial Estate, Rutland Road, Sheffield. S3 9QX. England.
Page 15
SERVICING 2. Hob Burner Gas valve removal/replacement • Shut off gas supply and disconnect gas supply pipe from the unit. • Remove the hob from the bench top. • Remove the appropriate control knob by pulling up. • From underside of hob, disconnect appropriate thermocouple at the gas valve. •...