Table of Contents
Advertisement
English Manual
6. Flash upgrade procedure
As part of the continual development and improvement process across the range of LINDY products, software
upgrades are occasionally made available. The LOCAL and REMOTE modules both contain internal flash
memory and LINDY's unique keyboard-link upgrade technique allows you to utilise software upgrades in a
straightforward manner.
Note: It is important to upgrade both the LOCAL and REMOTE modules together so that they are both running
the same new version of software.
Note: To upgrade the REMOTE module, a special keyboard connection cable is required. This cable must have
6pin mini-DIN male to 6pin mini-DIN male plugs with all lines connected - this is a common cable used with KVM
switches.
Do a flash upgrade ONLY when you experience problems!
To perform a flash memory upgrade, you need to perform the following stages:
•
Get the upgrade files from the LINDY technical support team
•
Create a startup diskette and copy the files to it
•
Reconfigure the LOCAL module connections and begin
•
Reconfigure the REMOTE module connections and begin
•
Return all connections to their usual states
6.1 Get the upgrade files from LINDY Technical Support
Please contact the LINDY Support team in your country by email, telephone or contact form from the LINDY
website. See
www.LINDY.com
Decompress the file you have received from LINDY. Depending on the chosen option, there will be collection of
suitable files.
As a minimum, there should be the following files:
AUTOEXEC.BAT – directs the computer to run the upgrade programs.
XKVMV2.EXE – this is the upgrade program that automatically determines which module is
connected and sends the appropriate firmware file.
XKVM.DAT – this file contains information about firmware versions and is used by the
XKVMV2.EXE to select the appropriate one.
X2GDLxxx.HEX, X2SLLxxx.HEX, X2STLxxx.HEX – these are the firmware files for the LOCAL
module.
X2GDRxxx.HEX, X2SLRxxx.HEX, X2STRxxx.HEX – these are the firmware files for the REMOTE
module.
Where xxx is the upgrade version number.
6.2 Create a startup disk
For this stage you will need a blank 3½'' floppy diskette that is either blank or has existing contents that are no
longer required. Depending on your operating system, use one of the following to create a startup disk:
To create a startup disk in Windows XP
1
Insert a disk into the floppy disk drive.
2
Select 'Start' and then 'My Computer'.
3
Right mouse click on the '3½ Floppy (A:)' icon and select 'Format'.
4
Check the 'Create an MS-DOS startup disk' box and select 'Start'.
To create a startup disk in Windows 95/98/Me
LINDY KVM Extender C5 PRO-300 Installation and Use
for all LINDY offices and contact information world wide.
page 23
Advertisement
Table of Contents
