1. Manuals
  2. Brands
  3. Lindy Manuals
  4. Switch
  5. 32416
  6. User manual

Lindy 32416 User Manual

Ipower control 8
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
User Guide
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (May 2005)
LINDY No. 32416
www.lindy.com
I
P
o
w
e
r
C
I
P
o
w
e
r
C
o
n
t
r
o
l
8
o
n
t
r
o
l
8
English

Advertisement

Table of Contents
loading

Related Manuals for Lindy 32416

Summary of Contents for Lindy 32416

  • Page 1 User Guide © LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - FIRST EDITION (May 2005) LINDY No. 32416 www.lindy.com English...
  • Page 2 LED next to the LAN input will illuminate. An IP address must be allocated to the IPower Control in order for it to switch via Ethernet. The IP address must belong to the desired sub network. The allocation can be accomplished either manually or automatically by a DHCP server (see 2.1 below).
  • Page 3 Login to the website of the IPower Control, http:// “IP Address of IPower Control” (e.g. 192.168.0.2). You may need to enter a password (see section 6). Now you can choose a port in order to reset it or switch it directly. The following options are available:...

  • Page 4: Port Configuration

    Label A name with a maximum of 15 characters can be entered here. After Power Up switch The ports state after a restart of the IPower Control can be defined here (on, off, last state) Delay A delay for the following port can be chosen here.

  • Page 5: Network Configuration

    IPower control. The admin password is ‘admin’. A user is authorized to switch and reset each port. (A user is not authorized to modify the settings of the ports or the IPower Control). The user password is ‘user’.

  • Page 6: Operating Modes

    9. FIRMWARE UPGRADE In order to upgrade the firmware both the IPCnet_conf.exe program and the latest firmware (available from www.lindy.com) are needed. Start the IPower Control in boot mode (see section 7) and launch IPCnet_conf.exe. On the left hand side of the program window all IPower Control units which are on the network are listed.

  • Page 7: 11. Technical Data

    10. DEFAULT SETTINGS In order to restore the default settings the IPower Control must be started in boot mode (see section 7). Launch IPCnet_conf.exe. After the program has opened, all IPower Control units which are on the network will be listed on the left hand side of the program window.
  • Page 8 12. FAQs Connection The IPower Control is connected to a network but..the LEDs do not illuminate Please check the connection to the electrical circuit ...the green LED at the LAN socket does not illuminate Please check the network connection ...I can’t open the website Please ensure that both the IPower Control and your PC are on the same sub network Where can I find the IP settings of my sub network?

Table of Contents