Manual Registration - Gamma Yealink W52P Full User Manual


Switch on the repeater (connect the power adapter).

The LED indicator on the repeater flashes. After a short while, the LED indicator stays on
permanently indicating that registration is completed, and the repeater is ready for use. The first LED
on the base station flashes after the registration is completed. You can press the paging key to
cancel the flash.
Note: If the registration is not successful, the LED indicator will flash continuously. In this case, repeat steps
from Switch off Repeater.

Manual Registration

The repeater, base station and handset must be accessible before performing the registration. If you want
to register more than one repeater, the registration must be performed separately for each repeater.
To register a repeater manually:

Set the repeater in registration mode.

Switch on the repeater for 1-5 seconds and then switch it off. Switch it on once more and leave it
there.
The LED indicator on the repeater flashes slowly. You now have five minutes to complete the registration.
If the registration is not completed within this period, you must start over again.

Set the base station in registration mode.

Long press the paging key on the base station till the first LED flashes.

The LED indicator on the repeater flashes.
If the LED flashes fast without interruptions, go to Assign a repeater number. If the LED flashes fast with
interruptions, go to Registration of handset.

Registration of handset.
You must re-register the handset even if the handset used was already registered to the base station. Now
the LED indicator flashes fast without interruptions.

Assign a repeater number.
You must now assign a repeater number to the repeater (choose from 2 to 7, for up to 6 repeaters):

Press #*9 and the off-hook key on the handset. The LED indicator illuminates.

Press a number between 2 and 7. When the repeater has accepted the chosen number, the LED
indicator will flash a corresponding number of times. If you miss the confirmation flash, press the
number again.

Accept the registration by pressing the * key, and then press the on-hook key. The repeater is now
automatically restarted: the LED indicator goes off for 2 seconds, flashes for a brief moment and
then stays illuminated. The registration of the repeater is completed. You can now disconnect the
power adapter and move the repeater to the selected location (disconnecting the power will not clear
the registration).
© Gamma 2014. All rights reserved. Confidential.