Led Status; Registering A Repeater; Auto Registration - Gamma Yealink W52P Full User Manual

LED Status

The DECT repeater has one LED indicator describing the repeater operations. The following table provides
instructions on repeater operations and LED indications:
LED Indication
Off
Red Slowly flashes
Red Double flashes
Red Steady on
Red Shortly flashes

Registering a repeater

The repeater can register to the base station in two ways:


Auto Registration


Manual Registration
Note: The "Repeater Mode" must be enabled on the base station. In order to do that, go to Main Menu 
Settings  System Settings  Repeater Mode  Change
Auto Registration
To register a repeater automatically:

Switch on the repeater and check if the LED indicator on the repeater double flashes. If the LED
indicator does not double flash, you need to de-register the repeater first. Please refer to "De-
registration". If the LED indicator double flashes, go to next step

Switch off the repeater (disconnect the power adapter).

Set the base station in registration mode. Long press the paging key on the base station till the first
LED flashes.
© Gamma 2014. All rights reserved. Confidential.
Operation
Power off
Unregistered, searching for base station
Searching for base station in the registration
mode or performing registration procedure.
Registered to base station, ready for use
Attempting handset connection